Verifying Henb-Gw Configuration - Cisco ASR 5x00 Home eNodeB Administration Manual

HeNB-GW Service Configuration Procedures

Verifying HeNB-GW Configuration

This section shows the configuration parameters configured for HeNB-GW service.
Step 1
Verify that your HeNB-GW services were created and configured properly by entering the following commands in Exec
Mode:
show henbgw-access-service <henbgw_access_svc_name>}
show henbgw-network-service <henbgw_network_svc_name>}
The output of these command display concise listing of HeNB-GW Access and Network service parameter
settings as configured on sym.
Step 2
Verify configuration errors of your HeNB-GW services by entering the following command in Exec Mode:
show configuration errors section henbgw-network-service}
The output of this command displays current configuration errors and warning information for the target
configuration file as specified for HNeB-GW Network service
Cisco ASR 5x00 Home eNodeB Gateway Administration Guide ▄
HeNB-GW Service Configuration ▀
43