Chapter 4 - Configuration; Accessing The Web-Based Configuration Interface - Buffalo AirStation NFINITI WHR-HP-G300N Firmware User Manual

Chapter 4 - Configuration

The web-based configuration interface lets you change AirStation settings. Don't change these
settings unless you know what you're doing.

Accessing the Web-based Configuration Interface

To configure the AirStation's advanced settings manually, log in to the web-based configuration interface
as shown below.
1
Launch a web browser.
2
Note: · The AirStation's default LAN-side IP address depends on the position of the mode switch.
In router mode: 192.168.11.1
In bridge mode: 192.168.11.100
If the router switch is set to AUTO and the unit is in bridge mode, then the AirStation's IP address was
assigned by an external DHCP server.
· If you changed the IP address of the AirStation, then use the new IP address.
3
WHR-HP-GN / WHR-HP-G300N User Manual
Enter the AirStation's LAN-side IP address in the address
field, and press the enter key.
When this screen appears, enter [root]
(in lower case) for the user name and the
password that you set during initial setup.
Click [OK].
Note: · By default, the password is blank (not set).
· If you forget your password, hold down the
Reset button (page 11) to initialize all
settings. The password will then be blank.
Note that all other settings will also revert to
their default values.
29