Hardware Overview; Front Panel Led's - Buffalo AirStation NFINITI WHR-HP-G300N Firmware User Manual

Chapter 1 Introduction

Hardware Overview

Front Panel LED's

5
ROUTER LED (Green)
6
DIAG LED (Red)
WHR-HP-GN / WHR-HP-G300N User Manual
1
AOSS Button
Hold down this button until the Security LED flashes
(approximately. 1 second) to initiate AOSS or WPS mode,
allowing the unit to exchange security keys with other AOSS
or WPS compatible devices. Power must be on for this to
1
work.
2
Power LED (Green)
2
On:
3
Off:
3
Security LED (Amber)
4
Indicates security status.
5
Off:
On:
6
Double blink:
Blinking: AOSS/WPS error; failed to exchange security keys
Note: When the Security LED is lit, an encryption key has
been set. Wireless clients will need the same key to
connect.
4
Wireless LED (Green)
Indicates wireless LAN status.
Blinking: Wireless LAN is transmitting
On:
On: Router functionality is enabled
Blinking: Router functionality is disabled
This indicates the status of the unit by the number of blinks per cycle.
Note: When the unit is first turned on or restarted, the Diag LED will
blink for almost a minute during boot. This is normal.
The AC adapter is connected
The AC adapter is not connected
Encryption is not set
Encryption has been set
The unit is waiting for an AOSS or WPS
security key
Wireless LAN is connected but not active
8