Linksys PAP2T User Manual page 29

10. Click the Enable checkbox for each port service you want to use.
11. When you are finished configuring Port Range Forwarding, click the click the Save Settings button.
5. The STATUS LED does not light up.
Go through this checklist until your problem is solved:
• Check the cable connecting the Phone Adapter to your router.
• Make sure your network has an active Internet connection. If it does not, follow these instructions to
reboot your cable or DSL modem, Phone Adapter, and router:
1. Power off your cable or DSL modem by unplugging its power adapter.
2. Power off the router by unplugging its power adapter.
3. Power off the Phone Adapter by unplugging its power adapter.
4. Wait two minutes, then power on your cable or DSL modem by plugging its power adapter into an
electrical outlet.
5. Wait two minutes, then power on the router by plugging its power adapter into an electrical outlet.
6. Wait five minutes, then power on the Phone Adapter by plugging its power adapter into an electrical
outlet.
7. Reboot one of your networked computers, and check to see if you have an active Internet
connection.
Appendix A:
Common Problems and Solutions
Internet Phone Adapter with 2 Ports for Voice-over-IP
25