Linksys PAP2T User Manual page 15

Action
Check DHCP
Enable/Disable DHCP
Check IP Address
Set Static IP Address
Check Network Mask (or Subnet
Mask)
Chapter 4: Using the Phone Adapter's Interactive Voice Response Menu
Using the Interactive Voice Response Menu
Interactive Voice Response Menu
Command (press these Choices
keys on the telephone)
100 —
101 Enter 1 to enable
Enter 0 to disable
110 —
111 Enter the IP address using the
numbers on your telephone
keypad. Use the
* (star) key to enter a decimal
point.
120 —
Internet Phone Adapter with 2 Ports for Voice-over-IP
Description
Use this command to find out if DHCP has been
enabled or disabled. If it is enabled, the Phone
Adapter will be assigned an IP address
automatically by your network router or gateway.
If it is disabled, then the Phone Adapter will need
to use a static
IP address.
Enable or disable the Phone Adapter's DHCP
feature. If your network router assigns IP
addresses, enter 1, otherwise, enter 0.
Use this command to check the current IP address
of the Phone Adapter.
To set a static IP address, the DHCP feature must
be disabled. If the DHCP feature is enabled, you
will hear, "Invalid Option," if you try to set a static
IP address.
Use this command to check the current network
mask of the Phone Adapter.
11