Cisco Catalyst 6000 Installation Note page 12

Installing the MSFC2
Carefully seat the MSFC2 onto the supervisor engine (see
Step 4
Using your thumbs, apply pressure at the locations shown in
Step 5
securely seated on the supervisor engine.
Ensure that the MSFC2 is securely seated before you install and tighten the cap nut and securing
Caution
screws. Using the screws to seat the MSFC2 could warp the card.
Use care not to damage the connectors on the supervisor engine. If you damage a connector, you will
Caution
have to return the supervisor engine to Cisco for repair.
Figure 6
Use a Phillips-head screwdriver to install the screws that secure the MSFC2 to the supervisor engine.
Step 6
(See Figure
You must install all screws. The screws provide grounding between the MSFC 2 and the supervisor
Caution
engine. Failure to install all screws will invalidate the safety approvals and can cause fire and
electrical hazards.
Catalyst 6000 Family Multilayer Switch Feature Card 2 Installation Note
12
Seating the MSFC2 on the Supervisor Engine
Apply pressure to
these areas
CONSOLE
PORT
,MODE
CONSOLE
SUPERVISOR 2
7).
Figure 6).
Figure 6 to ensure that the MSFC2 is
SWITCH LOAD PORT 1
100%
PCMCIA EJECT 1%
PORT 2
78-10605-03