Connecting An Fxs Line - Cisco 860 Series Hardware Installation Manual

Connecting an FXS line

Step 3 Snap the latches into the holes on either side of the power connector. See
Figure 3-11
1
3
Connecting an FXS line
Use a standard straight-through RJ-11 modular telephone cable to connect an Foreign Exchange Service
(FXS) port to a telephone or fax machine.
Warning This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do
not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11
port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming
call.
Warning For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection: FXS.
Cisco 860 Series and Cisco 880 Series Integrated Services Routers Hardware Installation Guide
3-14
Power Lock Clip Latched Into the Holes on Either Side of the Power Connector
4
Power lock clip
Power adapter
Chapter 3
Figure
1
2
3
2
Power cord
4
AC plug
Connecting the Router
3-11.
OL-16193-01