Connecting a G.SHDSL Line—G.SHDSL Port
Note
Connecting a G.SHDSL Line—G.SHDSL Port
To connect the router to a (global industry standard) symmetrical high-speed DSL (G.SHDSL) line,
follow these steps:
Connect one end of the lavender DSL cable to the G.SHDSL port on the router. See
Step 1
Figure 3-7
1
Step 2
Connect the other end of the cable to the DSL wall jack.
The DSL line must have been provisioned by your service provider and correctly configured so that the
Note
LED shows the carrier detect (CD) status. If the G.SHDSL CD LED is not on, check with your DSL
service provider.
Cisco 860 Series and Cisco 880 Series Integrated Services Routers Hardware Installation Guide
3-10
Follow the instructions from your Internet service provider to determine which modem port to
use.
Connecting the G.SHDSL Line
1
2
G.SHDSL port on the router
Chapter 3
2
DSL wall jack
Connecting the Router
Figure
3-7.
OL-16193-01