Connecting A Terminal Or Pc To The Console Port; Terminal Emulator Settings - Cisco 860 Series Hardware Installation Manual

Connecting a Terminal or PC to the Console Port

Connecting a Terminal or PC to the Console Port
Connect a terminal or PC to the Console Aux port either to configure the software by using the
command-line interface (CLI) or to troubleshoot problems with the router.
To connect a terminal or PC to the console port on the router and access the CLI, follow these steps:
Connect the RJ-45 end of a DB-9–to–RJ-45 serial cable to the RJ-45 Console Aux port on the router.
Step 1
Figure 3-4
Figure 3-4
1
Step 2 Connect the DB-9 end of the DB-9–to–RJ-45 serial cable to the to the COM port on your laptop or PC.
Note
To communicate with the router, start a terminal emulator application.
Step 3

Terminal Emulator Settings

Use the following settings for the terminal emulator connection:
•
•
•
Cisco 860 Series and Cisco 880 Series Integrated Services Routers Hardware Installation Guide
3-6
shows the RJ-45 end of the serial cable connected to the Console Aux port on the router.
Connecting a Terminal or PC to the Console Port
FE0 FE1 FE2 FE3
RJ-45 connector to the Console Aux port on
the router
Some laptops and personal computers do not come with DB-9 serial port connectors and may
use a USB-to-serial port adapter.
9600 baud
8 data bits, no parity
1 stop bit
1
2
DB-9 connector
Chapter 3 Connecting the Router
2
OL-16193-01