Figure 3-7 Ethernet Port Connections To Videoblox; Table 3-2 Rj45 Ethernet Pin Assignments - Honeywell ULTRAKEY LITE HJC5000 Installation And User Manual

Step 2: Configure the Controller for VideoBloX Mode
Document 800-07422 Rev A
08/10
Table 3-2 RJ45 Ethernet Pin Assignments
Port Pin
RJ45 Ethernet 1
2
3
6
1. Select the applicable adapter plug and insert it into the AC adapter. Push to click it
into place. See Figure
2. Plug the AC adapter into the controller power port and the adapter into a power
source.
3. Plug an RJ45 network cable from the network to the controller Ethernet port. Up to 32
controllers can be connected to the network. See
4. Connect VideoBloX to the network. Refer to the applicable
Guide for instructions.
Figure 3-7 Ethernet Port Connections to VideoBloX
VideoBloX
Note The controller factory defaults are VideoBloX mode, Address 1, baud rate
19200 bps. If any other mode has been selected then see
the Controller for VideoBloX Mode
Otherwise skip to the next step.
UltraKey Lite Controller Installation and User Guide
Signal
TX +
TX –
RX+
RX –
3-3.
Ethernet Port
TCP/IP
RJ45 network cables
Network
TCP/IP
on page
Figure 3-7.
VideoBloX Installation
Controller 1
Controller 32
Ethernet Port
Step 2: Configure
34 to select VideoBloX mode.
37