Equipment - Honda HHT31S Owner's Manual

CONTROLS & EQUIPMENT

EQUIPMENT

FULL SHOULDER HARNESS (UNBA only)
The Honda HHT25S and HHT31S trimmer/brush
cutters are supplied with a shoulder harness and
safety glasses. Refer to page 14 for a description
of other equipment and protective clothing you
will need.
Shoulder Harness
A full shoulder harness must be worn by the
operator of these Honda trimmers/brush cutters
when equipped with a blade and debris shield. If
the trimmer is equipped with a cutting-line head
QUICK-RELEASE LATCH
and shield with cutoff knife, the operator may
wear a single-strap harness
SINGLE-STRAP SHOULDER HARNESS (LTA only)
A suitable shoulder harness is supplied with each
new Honda HHT25S and HHT31S trimmer/brush
cutter. Replacement shoulder harnesses may be
purchased through any authorized Honda
trimmer/brush cutter servicing dealer.
Before operation, adjust your shoulder harness
as described on page 16.
QUICK-RELEASE LATCH
Quick-Release Latch
The shoulder harnesses supplied with these
LATCH TAB
trimmers are equipped with a quick-release latch.
Pull the latch tab upward to detach the trimmer
from the harness.
Insert the latch tongue in the slot of the quick-
release latch to reattach the trimmer to the
harness.
Safety Glasses
Safety glasses or goggles that comply with ANSI
(American National Standards Institute) standard
QUICK-RELEASE LATCH
Z87.1 must be worn by the operator of any
Honda trimmer/brush cutter. The safety glasses
supplied with each new Honda HHT25S and
SAFETY GLASSES (ANSI Z87.1)
HHT31S trimmer/brush cutter complies with this
ANSI standard.
13