Ethernet Cfm Mip - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

ethernet cfm mip

To globally provision maintenance intermediate points (MIPs) at a specified maintenance level for
VLAN IDs that are not associated with specific maintenance associations (MAs) and to enable level
filtering, use the ethernet cfm mip command in global configuration mode. To remove a MIP, use the
no form of this command.
Syntax Description auto-create
level
level-id
vlan
vlan-id
vlan-id-vlan-id
,vlan-id-vlan-id
lower-mep-only
sender-id
chassis
filter
Command Default MIPs are not provisioned.
Command Modes
Global configuration (config)
Command History Release
12.2(33)SXI2
OL-23890-01
ethernet cfm mip {auto-create level level-id vlan {vlan-id | vlan-id-vlan-id | ,vlan-id-vlan-id}
[lower-mep-only] [sender-id chassis] | filter}
no ethernet cfm mip {auto-create level level-id vlan {vlan-id | vlan-id-vlan-id | ,vlan-id-vlan-id}
[lower-mep-only] [sender-id {chassis | manage | chassis-manage}] | filter}
Dynamically creates a connectivity fault management (CFM) MIP.
Specifies a maintenance domain level.
Integer from 0 to 7 that identifies the maintenance level.
Indicates a VLAN for configuration.
Integer from 1 to 4094 that identifies the VLAN to be configured.
Integers from 1 to 4094 that define a range of VLANs to be configured.
•
Integers from 1 to 4094 that define a range of VLANs to be configured.
•
(Optional) Creates a MIP only if a MEP is configured at the next lower active
maintenance domain level for the VLAN ID on the port.
(Optional) Configures the Sender ID option to send for VLAN IDs that are
not associated with specific maintenance associations.
If the sender-id option is not configured, the Sender ID TLV is not included
in messages.
(Optional) Sends the chassis ID.
Configures a CFM MIP filter that drops all CFM frames at a lower level
independent of whether they come from the wire or relay function side.
•
Modification
This command was introduced.
The hyphen is required to separate the starting and ending VLAN ID
values that are used to define the range of VLAN IDs.
The comma is required to separate VLAN ranges.
Level filtering is disabled by default.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ethernet cfm mip
129