Table of Contents
Advertisement
WEP
Settings
Pre-shared Key
Bridge
Access Point Function Click Enable to make this router serving as an access point; click
Status
3
.
7
.
6
A
P
D
i
s
c
3
.
7
.
6
A
P
D
i
s
c
Vigor router can scan all regulatory channels and find working APs in the neighborhood.
Based on the scanning result, users will know which channel is clean for usage. Also, it can be
used to facilitate finding an AP for a WDS link. Notice that during the scanning process (about
5 seconds), no client is allowed to connect to Vigor.
This page is used to scan the existence of the APs on the wireless LAN. Yet, only the AP
which is in the same channel of this router can be found. Please click Scan to discover all the
connected APs.
Vigor2100 Series User's Guide
Check this box to use the same key set in Security Settings page. If
you did not set any key in Security Settings page, this check box
will be dimmed.
Encryption Mode - If you checked the box of Use the same WEP
key ..., you do not need to choose 64-bit or 128-bit as the
Encryption Mode. If you do not check that box, you can set the WEP
key now in this page.
Key Index - Choose the key that you want to use after selecting the
proper encryption mode.
Key - Type the content for the key.
Type 8 ~ 63 ASCII characters or 64 hexadecimal digits leading by
"0x".
If you choose Bridge as the connecting mode, please type in the peer
MAC address in these fields. Six peer MAC addresses are allowed to
be entered in this page at one time. Yet please disable the unused
link to get better performance. If you want to invoke the peer MAC
address, remember to check Enable box in the front of the MAC
address after typing.
Disable to cancel this function.
It allows user to send "hello" message to peers. Yet, it is valid only
when the peer also supports this function.
o
v
e
r
y
o
v
e
r
y
77
Advertisement
Table of Contents
