Makita N5900B Instruction Manual
  1. Manuals
  2. Brands
  3. Makita Manuals
  4. Saw
  5. N5900B
  6. Instruction manual
Makita N5900B Instruction Manual

Makita N5900B Instruction Manual

Double insulation
Hide thumbs Also See for N5900B:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Instruction Manual
INSTRUCTION MANUAL

Circular Saw

N5900B
004321
DOUBLE INSULATION
WARNING:
For your personal safety, READ and UNDERSTAND before using.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
1

Advertisement

Table of Contents
loading

Related Manuals for Makita N5900B

Summary of Contents for Makita N5900B

  • Page 1: Circular Saw

    INSTRUCTION MANUAL Circular Saw N5900B 004321 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

  • Page 2: Specifications

    3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN fluctuations. The operation of this device under Authorized Representative in Europe: unfavorable mains conditions can have adverse effects Makita International Europe Ltd. to the operation of other equipment. With a mains Michigan Drive, Tongwell, Milton Keynes, Bucks MK15...

  • Page 3: General Power Tool Safety Warnings

    8JD, ENGLAND Do not use a power tool while you are tired or GEA005-2 under the influence of drugs, alcohol or medication. A moment of inattention while General Power Tool Safety operating power tools may result in serious Warnings personal injury. Use personal protective equipment.

  • Page 4: Specific Safety Rules

    and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. 22. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.
  • Page 5 the blade. Kickback could cause the saw to jump backwards, but kickback forces can be controlled operator, proper precautions are taken. When blade binding, when • interrupting a cut for any reason, release the trigger and hold the saw motionless in the material until the blade comes to a complete stop.
  • Page 6 possible kickback. Push the saw forward at Fig. 1 a speed so that the blade cuts without slowing. 10. Check lower guard for proper closing before each use. Do not operate the saw if lower guard does not move freely and close instantly. Never clamp or tie the lower guard into the open position.

  • Page 7: Functional Description

    when use the tool. Sighting 1. Base plate SAVE THESE INSTRUCTIONS. 2. Cutting line WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. FUNCTIONAL DESCRIPTION 004324 CAUTION: For straight cuts, align the A position on the front of the Always be sure that the tool is switched off and base with your cutting line.

  • Page 8: Operation

    Remove the lever attached to the main unit and attach at the front of the tool. lever of joint set. Use only the Makita wrench to install or remove the • blade. To remove the blade, press the shaft lock so that the blade cannot revolve and use the wrench to loosen the hex bolt counterclockwise.

  • Page 9: Maintenance

    If you need any assistance for more details regarding the screw on the front of the base. It also makes these accessories, ask your local Makita Service Center. repeated cuts of uniform width possible. Saw blades •...
  • Page 12 Makita Corporation Anjo, Aichi, Japan 884505-222...

Table of Contents