Chapter 11 - Utilities; To Add A Test Code I.d. Prefix To All Symbologies; Show Decoder Revision; Show Engine Revision - Honeywell 4600g User Manual

11
Utilities

To Add a Test Code I.D. Prefix to All Symbologies

This selection allows you to turn on transmission of a Code I.D. before the
decoded symbology. (See the Symbology Chart, included in the
A, page A-1) for the single character code that identifies each symbology.) This
action first clears all current prefixes, then programs a Code I.D. prefix for all
symbologies. This is a temporary setting that will be removed when the unit is
power cycled.

Show Decoder Revision

Scan the barcode below to output the decoder revision.
Note: You may use the Show Decoder Revision option if you have firmware with
a base number of 31205480. Refer to
11-2 for information on determining the firmware revision in your unit.

Show Engine Revision

Note: You may use the Show Engine Revision option if you have firmware with
a base number of 31205480.
Scan the barcode below to output the engine revision. Your imager returns the
engine type, revision number, and status character [ACK]. For example, an
imager with a 5100 engine, version 26 would return:
ENGREVType:
Add Code I.D. Prefix to
All Symbologies (Temporary)
Show Decoder Revision
1 Revision: 26[ACK]
Show Engine Revision
Show Software Revision
Appendix
on page
11 - 1