Trigger Commands; Resetting The Standard Product Defaults; Menu Commands - Honeywell 4600g User Manual

Trigger Commands

You can activate and deactivate the imager with serial trigger commands. First,
the imager must be put in Manual/Serial Trigger Mode either by scanning the
Manual/Serial Trigger Mode barcode
Serial Menu Command
the trigger is activated and deactivated by sending the following commands:
Activate: SYN T CR
Deactivate: SYN U CR
The imager scans until a barcode has been read, until the deactivate command
is sent, or until the serial time-out has been reached (see "Read Time-Out" on
page 3-4 for a description, and the serial command on

Resetting the Standard Product Defaults

If you aren't sure what programming options are in your imager, or you've
changed some options and want the factory settings restored, scan the Stan-
dard Product Default Settings barcode below.
The chart on the following pages lists the factory default settings for each of the
menu commands (indicated by an asterisk (*) on the programming pages).

Menu Commands

Note: Not all menu commands apply to all imager models.
Selection
Factory Default
Settings
Terminal Interfaces
Terminal ID
12 - 4
(page
(page 12-9). Once the imager is in serial trigger mode,
Standard Product Default Settings
Setting
* Indicates default
Default
000 (4600g/4600r/4600rp/
4800i 030 models)
124 (4600g/4600r/4600rp/
4800i 050 models)
3-4), or by sending the Manual/
page
Serial
Command
# Indicates a
numeric entry
DEFALT
TERMID###
12-9).
Page
12-4
2-1