Wireless Repeating Function - NETGEAR WNR612v3 User Manual

The WNR612v3 router is always in dual band concurrent mode, unless you turn off one radio.
If you enable the wireless repeater in either radio band, the wireless base station or wireless
repeater cannot be enabled in the other radio band. However, if you enable the wireless base
station in either radio band and use the other radio band as a wireless router or wireless base
station, dual band concurrent mode is not affected.
To set up a wireless network with WDS, both access points have to meet the following
conditions:
Both access points have to use the same SSID, wireless channel, and encryption mode.
•
Both access points have to be on the same LAN IP subnet. That is, all of the access point
•
LAN IP addresses are in the same network.
All LAN devices (wired and wireless computers) are configured to operate in the same
•
LAN network address range as the access points.

Wireless Repeating Function


To view or change the wireless repeater settings for the router:
Select Advanced > Advanced Setup > Wireless Repeating.
The following settings are available:
Enable Wireless Repeating Function. Select the check box for the to use the wireless
•
repeating function.
Wireless MAC of this router. This field displays the MAC address for your router for
•
your reference. You will need to enter this MAC address in the corresponding Wireless
Repeating Function screen of the other access point you are using.
Wireless Repeater. If your router is the repeater, select this check box.
•
Repeater IP Address. If your router is the repeater, enter the IP address of the other
access point.
Disable Wireless Client Association. If your router is the repeater, selecting this check
box means that wireless clients cannot associate with it. Only LAN client associations are
allowed.
N150 2-Port Wireless Router WNR612v3
Advanced Settings
63