NETGEAR WNR612v2 - Wireless-N 150 Router Installation Manual

4 Press the WPS button on the router. It will look similar to
or .
5. Within 2 minutes, follow the wireless software instructions
on the wireless device to complete the WPS process. The
device will then be connected to your router. Repeat this
process to add other wireless devices.
Note: Your network name, security method and
passphrase must be the same on all wireless devices
connected to your router.
Enter your wireless information here:
Wireless Network Name (SSID)
________________________________
Wireless Security Passphrase
__________________________________
If you forget your Passphrase, connect a computer to the
router using an Ethernet cable and log in to http://
www.routerlogin.net
and enter the default User Name
(admin) and Password (password).
Restore Factory Default: For some routers, you may
need to reset the device to its factory default first, then
reconfigure your Passphrase. To restore factory defaults,
use a paper clip to press the recessed reset button on the
back until the Power/Test light blinks. This takes about 10
seconds. Release the button and wait for the router to
reboot. Log in with the default username (admin) and
password (password).
Note: Restoring factory defaults will erase any
customizations and you will lose any configurations
saved to the device!
LED Activity
Item Description
Power /Test • Blinking green: Router is performing the
power-on, self-diagnostic test.
• Solid green: The router is ready.
• Solid green: Wireless connection is
Wireless
established.
• Blinking green: Data is being
communicated.
• Off. The wireless interface is turned off.
Internet • Solid green: Wireless router has a valid
(Blue RJ-45
link on the internet or WAN port.
connector)
• Blinking green: Data is being
communicated.
• Off: There is no Ethernet cable connected
to the modem.
LAN Ports • If a LAN light is off, be sure the Ethernet
(Yellow
cable is securely attached at both ends,
RJ-45
and that the computer is turned on.
connectors)
• Solid green: Local port is connected to a
10 or 100 Mbps device.
• Blinking green: Data is being transmitted
at 10 or 100 Mbps.

Technical Support

Thank you for selecting NETGEAR products.
After installing your device, locate the serial number on the
label of your product and use it to register your product at
http://www.NETGEAR.com/register . Registration is required
before you can use the telephone support service. Registration
via our website is strongly recommended.
Go to http://kbserver.netgear.com for product updates and Web
support .
For additional information about setting up, configuring, and
User Manual
using your Product Name Only, see the
For complete DoC please visit the NETGEAR EU Declarations of
Conformity website at: http://kb.netgear.com/app/answers/detail/
a_id/11621/
GPL may be added in this product; go to
ftp://downloads.netgear.com/files/GPLnotice.pdf
to view the GPL
license agreement.
This symbol was placed in accordance with the European
Union Directive 2002/96 on the Waste Electrical and
Electronic Equipment (the WEEE Directive). If disposed of
within the European Union, this product should be treated and
recycled in accordance with the laws of your jurisdiction implementing
the WEEE Directive.
©2010 by NETGEAR, Inc. All rights reserved. NETGEAR and the
NETGEAR logo are registered trademarks of NETGEAR, Inc. in the
United States and/or other countries. Other brand and product names
are trademarks or registered trademarks of their respective holders.
Information is subject to change without notice.
September 2010
Wireless-N 150 Router
WNR612v2
Package Contents
.
Installation Guide