Clearing Jammed Staples - Grizzly H7677 Instruction Manual

To operate your stapler in bump fire
mode:
1. Push the trigger switch IN (Figure 7).
Figure 7. Trigger switch, bump fire mode.
2. Pull the trigger.
3. Press the safety yoke mechanism
against your workpiece and raise it
after the staple is driven.
4. Hold the trigger and repeat Step 3 to
drive more staples.
Clearing Jammed
Staples
A jammed staple must be cleared before
using the stapler again. The two places
where a staple can get jammed are the
magazine and the discharge area.
To clear a jammed staple from the dis-
charge area:
1. DISCONNECT
THE AIR SUPPLY!
2.
Pull back and latch the magazine.
3.
Remove the staple from the maga-
zine.
-12
-
STAPLER FROM
4. Loosen the cap screws shown in
Figure 8 and remove the nose cover.
Nose Cover
Figure 8. Loosening cap screws on cover.
5.
Remove the jammed staple with nee-
dle nose pliers.
6.
Secure the safety cover with the cap
screws removed in Step 4.
7.
Throw the damaged staple away.
8.
Inspect the staple stick. If it is bent or
damaged, insert a new staple stick
that only contains clean, undamaged
staples. DO NOT use dirty or damaged
staples!
9.
Latch the magazine closed.
H7677 18 Gauge Stapler Kit
Cap Screw