Table of Contents
Advertisement
SECTION 7: MAINTENANCE
General
Regular periodic maintenance on your Model
G5959Z will ensure its optimum performance.
Check for the following conditions each time you
use your table saw.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged V-belt.
5. Inspect blade for damage.
6. Guard alignment and operation.
7. Any other condition that could hamper the
safe operation of this machine.
!
-32-
Disconnect power to the
machine when perform-
ing any maintenance or
repairs. Failure to do this
may result in serious
personal injury.
Keep
loose
clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses dur-
ing the entire mainte-
nance process. Failure
to comply may result in
serious personal injury.
Table
Table can be kept rust-free with regular applica-
tions of products like Boeshield
term storage you may want to consider products
like Kleen Bore's Rust Guardit™.
V-Belt
V-belts must be in good condition and correctly
tensioned to ensure optimum power transmission
from the motor to the blade. When replacing V-
belts, it is important to replace all four at the same
time - even if they do not appear worn.
Belt tension should be checked at least every 3
months; more often if using the table saw inten-
sively. The V-belts are accessed through the cav-
ity on the left side of the saw.
To check V-belt tension:
1.
Disconnect the table saw from the power
source.
Squeeze the center of each V-belt.
2.
3.
Note the amount of deflection. Deflection
should be approximately
Figure 42.
3
⁄
"
4
Figure 42. Proper amount of V-belt deflection.
G5959Z 12" Left-Tilting Table Saw
®
T-9. For long
3
⁄
" as shown in
4
Advertisement
Table of Contents
