Section 6: Operations; Pre-Run Check; Test Run - Grizzly G5959Z Instruction Manual

SECTION 6: OPERATIONS

Pre-Run Check

Before you begin to use your Model G5959Z 12"
Left-Tilt Table Saw, you should give it a thorough
inspection and ask yourself the following ques-
tions:
1. Are all the fasteners tight?
2. Is the blade mounted correctly?
Is the saw stable?
3.
Is it wired properly?
4.
Is your electrical system properly config-
5.
ured?
Are the V-belts correctly tensioned and the
6.
pulleys properly aligned?
7. Is the guard assembly installed and func-
tional?
8. Have you checked the saw blade clearance
when it is adjusted to varying angles and
depths?
9. Have you read all warnings and directions
regarding the operation of this machine?
!
G5959Z 12" Left-Tilting Table Saw
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury.

Test Run

Face the table saw and stand to the right of
1.
the blade path.
With one finger on the START button and
2.
one finger on the STOP button, turn the saw
on. Be ready to turn it off in case of mishap.
Watch and listen to the saw. Note whether
3.
there are any unusual sounds or excessive
vibrations.
4. Turn off the saw. If anything is abnormal,
stop and fix the problem. If a problem exists
that is beyond the scope of this manual, call
our service department. If the saw is behav-
ing normally, prepare to make a cut accord-
ing to the instructions outlined in the follow-
ing sections.
Always wear a dust
mask when operating
the G5959Z. Using this
machine produces saw-
dust which may cause
allergic reactions or res-
piratory problems.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses dur-
ing the entire operations
process. Failure to com-
ply may result in serious
personal injury.
-25-