Table of Contents
Advertisement
Rabbeting operations can also be accomplished
using a conventional saw blade. To create a sin-
gle-blade rabbet:
Clearly mark the width of the rabbet cut on
1.
your workpiece. Include marks on the edge
of your workpiece so you can clearly identify
your intended cut while the material is laying
flat on the saw table.
2.
Set the blade height to the depth of cut you
wish to create.
If the rabbet runs the length of the material,
3.
adjust the fence so the blade is aligned with
the inside of your rabbet channel.
Turn on your saw and make the first cut.
4.
5.
Turn off the saw and re-adjust the fence so
that the next cut will remove another portion
of the wood stock between the inside edge of
the rabbet and the edge of the wood.
G5959Z 12" Left-Tilting Table Saw
Turn on the saw and make a second cut.
6.
7.
Continue to re-adjust the blade and cut until
the entire rabbet is made.
8.
Re-install the blade guard.
Instructions on using moulding heads have
been intentionally left out. They are very
dangerous
when
Considerable skill and training beyond the
scope of this manual are required to safely
operate a moulding head. Serious personal
injury could result if this warning is not fol-
lowed.
not
used
properly.
-31-
Advertisement
Table of Contents
