Cisco Ucs B200 M3 Blade Server; Leds - Cisco UCS B200 M3 Installation Manual

Revised: September 9, 2013, OL-26624-01

Cisco UCS B200 M3 Blade Server

The Cisco UCS B200 M3 is an Intel-based, half-width blade supporting two CPU sockets using Intel E5-2600 series CPUs and up
to 24 DIMMs; it supports one modular LOM (dedicated slot for Cisco's Virtual Interface Card) and one mezzanine adapter. At this
time, the UCS B200 M2 (second generation) server is still available and is documented elsewhere. You can install up to eight UCS
B200 Blade Servers to a UCS chassis, mixing with other models or Cisco UCS blade servers in the chassis if desired.
Figure 1: Cisco UCS B200 M3 Front Panel
1 Asset tag
Each server has a blank plastic tag that pulls out of the
front panel which is provided so that you can add your
own asset tracking label without interfering with the
intended air flow.
2 Blade ejector handle
Ejector captive screw
3
4 Hard drive bay 1
5 Hard drive bay 2
6 Power button and LED

LEDs

Server LEDs indicate whether the blade server is in active or standby mode, the status of the network link, the over all health of the
blade server, and whether the server is set to give a flashing blue beaconing indication.
The removable drives also have LEDs indicating hard disk access activity and disk health.
2
7 Network link status LED
8 Blade health LED
Console connector
9
10 Reset button access
11 Beaconing LED and button