Cisco SPA Phones User Manual page 17

described, you should have successfully registered your phone to PBXware. Dial
*123 to verify registration.
DNS SRV
4.2.3.3
This chapter describes how to use a DNS SRV record which specifies the location of the
N O TE
PBXware.
Bicom Sy stem s can prov ide serv ice to set up this for y ou.
1. Check if the DNS SRV is enabled in your PBXware
Contact your PBXware administrator to find out if the DNS SRV is enabled in your
PBXware, or if you have access to the PBXware you can check this yourself.
Open a new browser window and enter the IP address in order to access the
PBXware web administration login screen. Example: http://192.168.1.10
Login to PBXware with your e-mail address and password.
Navigate to Settings: Servers. Click on the server corresponding edit button.
In Auto Provisioning group, make sure Use DNS SRV when possible: is set
to Yes. If it is set to No or N/A, set to Yes and click on the Save button.
N O TE
2. Login to phone web administration interface
If there is no DHCP in your network, you can still auto provision your Cisco SPA phone.
Please refer to your Cisco SPA phone model User Guide for instruction about setting
static IP address. After you configure your Cisco SPA phone to use a static IP address,
continue with the following steps.
Open a new browser window and enter your phone IP address in order to access
the phone web administration interface login screen. Example:
http://192.168.1.22
© 2003 - 2012 Bicom Systems
Y our DNS Serv er needs to be configured correctly for this to work.
Y ou m ust re-sav e all y our ex tensions configured for Auto Prov isioning.
Registering Phone 15