Resetting The Ip Camera - Cisco 6400 Installation Manual

Chapter 4 Camera Management
You also can also perform these reset operations from the Maintenance Settings window as described in
the Cisco Video Surveillance 6000 Series IP Camera Configuration Guide.
Table 4-3
Reset Type
Reboot.
Factory reset.
Viewing Live Video
After you install and set up the Cisco Video Surveillance IP Camera, you can connect to the IP camera
through Internet Explorer and access the Camera Video & Control window to view live video.
The Camera Video & Control window also provides for controlling the video display, configuring preset
positions, and controlling certain IP camera functions. Available controls depend on the privilege level
of the user.
To view live video, log in to the IP camera, then click View Video in the IP camera Main window menu
bar. The Camera Video & Control window appears. This window displays live video from the camera
and lets you control a variety of camera and display functions.
The controls that you see in the Camera Video & Control window depend on your IP camera privilege
level and the configurations settings for the IP camera. Users with the Administrator privilege can access
all controls. Users with the Viewer privilege do not have access to the following controls:
•
•
Table 4-4
Table 4-4
Control
Video controls
Video Codec
drop-down list
OL-28494-01

Resetting the IP Camera

Video image controls
Motion detection controls
describes the controls in the Camera Video & Control window.
Camera Video & Control Window Controls
Description
Choose the codec for video transmission (H.264 or MJPEG).
You can choose H.264 only if the primary video stream (channel 1) is enabled.
You can choose MJPEG only if the secondary video stream (channel 2) is
enabled.
Procedure
Press and immediately release
the Reset button.
Press and hold the button for at
least 15 seconds.
Cisco Video Surveillance 6400 IP Camera Installation Guide
Viewing Live Video
Remarks
This action is equivalent to
powering the IP camera down
and then powering it up. Settings
that are configured for the IP
camera are retained.
Sets all IP camera options to
their default values. After you
perform this procedure, follow
the steps in the "Performing the
Initial Setup of the IP Camera"
section on page 3-1.
4-5