Table of Contents
Advertisement
Connecting External Power and I/O Cables
Feed the external power cable and I/O cables through the wall mount bracket and the waterproof
Step 4
connector components (E –> D –> B –> A). Be sure to feed enough cable length through the waterproof
connector to connect the cables to the GPIO terminal block.
Note
There are seven holes on the seal (B), and the widest hole with a crack on the side is specific for the
power cable.
The recommended I/O cable gauge is 2.0 ~ 2.8 mm.
Push the seal (B) into the housing (D), and to avoid moisture, insert the seals (C) into the empty holes
Step 5
on the seal (B).
Cisco Video Surveillance 6400 IP Camera Installation Guide
2-6
(A)
(B)
(D)
(E)
4
(E)
(B)
(C)
(D)
Chapter 2
Camera Installation
OL-28494-01
Advertisement
Table of Contents
