Connecting A Waterproof Ethernet Cable - Cisco 6400 Installation Manual

Video surveillance 6400 high-definition ip camera

Hide thumbs Also See for 6400:

Table of Contents

Connecting a Waterproof Ethernet Cable

To connect the 6400 IP camera to an Ethernet cable with a waterproof connection, perform the following

steps.

Procedure

Disassemble the components of the waterproof connector into its individual components as shown

Step 1

below.

Strip about 1/2 inch (12 mm) of the sheath off the end of an Ethernet cable.

Step 2

Insert the housing (D) into the screw nut (C).

Step 3

(C)

Insert the seal (B) into the housing (D).

Step 4

(B)

Insert the stripped Ethernet cable through the sealing nut (A) and the housing (D).

Step 5

Clamp the cable with an RJ45 plug.

Step 6

Cisco Video Surveillance 6400 IP Camera Installation Guide

2-8

Sealing Nut (A)

Seal (B)

Screw Nut (C)

Housing (D)

Gasket (E)

1/2 in. (12 mm)

(D)

(A)

Chapter 2

Camera Installation

OL-28494-01

Table of Contents