Obibluetooth Call Feature - Obihai OBi100 Administration Manual

After an initial pairing and connection with the mobile phone, OBiBT will automatically request connection with the same
phone next time it comes in range. If it still remembers the pairing information with OBiBT, your mobile phone would also
quietly accept the connection request.
You can find the device pairing information for the last 10 paired devices on the OBiBlueTooth device web page under the
Device Settings section. A screenshot of this page is shown below. There are two parameters for each paired device X,
where X = 1, 2, ..., 10:
- PairedDeviceX – The name of the paired device.
- RemovePairedDeviceX – Check this box and press the submit button to remove this device from the paired device
list.
Some exceptions:
- If the pairing information is removed from the mobile phone after initial pairing and connection with OBiBT, the
next time it comes in range with OBiBT, the phone may pop up a message to let you know that the device "OBi" is
requesting connection. You may then manually accept the connection.
- If the pairing information is removed from the OBi after initial pairing and connection with a mobile phone, it will
not automatically connect with the phone next time it comes in range. You must then go to your mobile phones's
Bluetooth setup screen and explicitly select the paired device "OBi" to re-establish connection
- OBi remembers the paired devices based on particular OBiBT dongle that is used during pairing. Each OBiBT dongle
has a different hardware ID. If you replace the dongle with a different one, the existing device pairing information
will not be valid and OBi will not be able to recognize the previously paired devices when they are in range
OBiBlueTooth Call Features
OBiBlueTooth is the voice service that is made possible with an attached OBiBT dongle that is connected with a (in-service)
mobile device. This service allows you to make or receive mobile calls using a conventional phone attached to the OBi
phone port, or by bridging in a VoIP call over a SP service or OBiTALK service. OBiBlueTooth only allows one incoming or
outgoing call on OBiBT at a time. In other words, there is no 3-way call or call-waiting support on OBiBlueTooth. The
supported call features are similar to the equivalent ones supported under SP or OBiTALK service.
The screenshot below shows the Calling Feature parameters on the OBiBluebooth device web page, which should be self-
explanatory.
Copyright 2010-2013 Obihai Technology, Inc. 134