Video Settings; Video Allowwebsnapshots; Video Camctrlpip Callsetup Duration; Video Defaultpresentationsource - Cisco TelePresence SX20 Quick Set Administrator's Manual

Cisco TelePresence SX20 Quick Set
Contents

Video settings

Video AllowWebSnapshots

Allow or disallow snapshots being taken of the local input sources, remote sites and
presentation channel. If allowed, the web interface Call Control page will show snapshots both
when idle and in a call.
NOTE: This feature is disabled by default, and must be enabled from the on-screen menu, from
a directly connected Touch control panel, or via the codec's serial port (USB port and RS-232
adapter).
Requires user role: ADMIN
Value space: <Off/On>
Off: Capturing web snapshots is not allowed.
On: Web snapshots can be captured and displayed on the web interface.
Video AllowWebSnapshots: Off
Example:

Video CamCtrlPip CallSetup Mode

This setting is used to switch on self-view for a short while when setting up a call. The Video
CamCtrlPip CallSetup Duration setting determines for how long it remains on. This applies when
self-view in general is switched off.
Requires user role: ADMIN
Value space: <Off/On>
Off: self-view is not shown automatically during call setup.
On: self-view is shown automatically during call setup.
Video CamCtrlPip CallSetup Mode: Off
Example:
D14908.06 SX20 Administrator Guide TC7.0, DECEMBER 2013.
Introduction Web interface System settings System settings

Video CamCtrlPip CallSetup Duration

This setting only has an effect when the Video CamCtrlPip CallSetup Mode setting is switched
On. In this case, the number of seconds set here determines for how long self-view is shown
before it is automatically switched off.
Requires user role: ADMIN
Value space: <1..60>
Range: Choose for how long self-view remains on. The valid range is between 1 and 60
seconds.
Video CamCtrlPip CallSetup Duration: 10
Example:

Video DefaultPresentationSource

Define which video input source shall be used as the default presentation source when you
press the Presentation key on the remote control. If using the Touch screen control panel
this setting has no effect. The Video Input Source n Connector setting defines which input
connector to use for input source n.
Requires user role: USER
Value space: <1/2>
Range: Select the video source to be used as the presentation source.
Video DefaultPresentationSource: 2
Example:
www.cisco.com — Copyright © 2012-2013 Cisco Systems, Inc. All rights reserved.
97
Administrator Guide
Setting passwords Appendices