GE 15339430 User Manual page 12

• Two single RJ11 wall jacks.
Connect the other end of the line cord
to a 2-line adapter (not
provided). Then connect the adapter
to the wall jacks with two short
telephone line cords (also not pro-
vided).
If you want to connect LINE 3 and 4, use
the same procedure as in step 1.
2. For the handset, connect one end of
the coiled handset cord to the jack on
the side of the base unit. Take the
other end of the cord and plug it into
the jack at the bottom of the handset.
Then place the handset in the cradle.
3. Plug the AC power supply cord into
the jack on the back of the unit labeled
AC 9V. Thread the cord behind the
strain relief to stabilize the cord to
prevent it from disconnecting easily.
Then plug the AC power supply into
an electrical outlet.
4. Follow the steps in "Setting Up Your
Station Address" to continue install-
ing your phone.
CAUTION: Use only the Thomson 5-2418
power supply that is compatible with this unit.
Using other power supplies may damage the
unit.
8
2
STORE IN TIMER TIME SET MEMO REVIEW LOWER
1 2 3 4
5 6 7 8
PAGE
9 10 11 12
13 14 15 16
BUSY REDIAL FLASH PAUSE TRANSFER CONF CALL
1 2 3
PRIVACY
ABC DEF LINE 4
4 5 6
LINE 3
GHI JKL MNO
7 8 9
LINE 2
PQRS TUV WXYZ
VOLUME
* 0 #
LINE 1
T ONE OPER
HEADSET MUTE SPEAKERPHONE HOLD INTERCOM
3