GE D20MX User Manual page 107

APPENDIX D: USING CONFIGPRO WITH D20MX
D20MX HARDWARE USER'S MANUAL
Note: Step 3.3 applies because the D20MX factory default configuration was
restored to a different project location - C: drive, as shown above. If this is not
the case, right-click on an empty space within the project's main page and click
on Firmware to confirm that the SAN0001/02 firmware has been automatically
added to the list of firmware within the firmware library, then proceed to
step 3.4.
3.3. Open the restored factory default configuration file.
3.3.1. Navigate to the project directory where the factory default configuration
was restored.
3.3.2. Open the file.
3.3.3. Use the Projects and Windows tab to switch screen content. The
Windows tab allows access to different projects.
GE INFORMATION 107