Port Mode By Using Encapsulation Default - Cisco ASR 903 Manual

▀ Port mode by using Encapsulation Default

encapsulation dot1q 200-300
rewrite ingress tag push dot1q 300 symmetric
l2vpn xconnect context PW200
member GigabitEthernet0/1/0 service-instance 1
member 10.10.4.4 200 encapsulation mpls
ASR903-PE2 Configuration
! create a pesudowire interface
interface pseudowire200
encapsulation mpls
neighbor 10.10.3.3 200
interface GigabitEthernet0/1/0
no ip address
negotiation auto
no keepalive
service instance 1 ethernet
encapsulation dot1q 200-300
rewrite ingress tag push dot1q 300 symmetric
l2vpn xconnect context PW200
member GigabitEthernet0/1/0 service-instance 1
member pseudowire200
Port mode by using Encapsulation Default
Important:
ASR903-PE1 Configuration
interface GigabitEthernet0/1/0
no ip address
negotiation auto
no keepalive
service instance 1 ethernet
encapsulation default
xconnect 10.10.4.4 100 encapsulation mpls
ASR903-PE2 Configuration
interface GigabitEthernet0/1/0
no ip address
negotiation auto
no keepalive
service instance 1 ethernet
encapsulation default
xconnect 10.10.3.3 100 encapsulation mpls
▄ Cisco ASR 903 Router Design and Deployment Guide
58
Port mode is not supported on ASR903 but encapsulation default can be used as a workaround.
! use l2vpn context
! use l2vpn context
! this encapsulation catches all
Ethernet over MPLS
OL-30526-01