Table of Contents
Advertisement
Installation
Instructions
MOBILE HOME INSTALLATION
• Installation must conform to Manufactured Home
Construction and Safety Standard, Title 24 CFR,
Part 32-80.
• The dryer must be exhausted to the outside with
the termination securely fastened to the mobile
home structure.
• The exhaust MUSTNOT be terminated beneath
the mobile home.
• The exhaust duct material MUSTNOT support
combustion.
• For Electrical Connections see CONNECTING APPLIANCE
USING4-WIRE CONNECTION.
CONSIDERATION MUST BEGIVEN TO PROVIDEADEQUATE
CLEARANCES FOR INSTALLATION AND SERVICE.
ALCOVE OR CLOSET INSTALLATION
1"_,,_
0"_
_
0.....
0"
60
60
.
• If your dryer is approved
for installation
in an alcove
or closet, it will be stated on a label on the back of
the dryer.
• TO PREVENT LARGE AMOUNTS OF LINT AND MOISTURE
FROM ACCUMULATING AND TO MAINTAIN DRYING
EFFICIENCY, THIS MACHINE MUST BE EXHAUSTED
OUTDOORS.
• DO NOT install this appliance with less than
the minimum clearances shown above.
CONSIDERATION MUST BE GIVEN TO PROVIDE ADEQUATE
CLEARANCES FOR INSTALLATION AND SERVICE.
-ACAUTION:
DO NOT INSTALL THIS APPLIANCE
IN A CLOSET WITH A SOLID DOOR.
DOOR VENTILATION
OPENING
A minimum of 120 square inches of opening, equally
divided at top and bottom, is required. Air openings are
required to be unobstructed when a door is installed.
A Iouvered door with equivalent air openings for the
full length of the door is acceptable.
When louvers or registers are placed in door openings,
the free air openings of the louvers or registers must
equal 120 square inches.
MISCELLANEOUS
REQUIREMENTS
LOCATION
• The appliance must be installed on firm flooring to
minimize vibration during spin cycles. Concrete flooring
is best, but wood base is sufficient, provided the floor
support meets FHA standards.
• The appliance should not be installed on rugs or
exposed to the weather.
INSIDE EXHAUSTING
• If the installation makes it possible to exhaust to the
outside, there must be a clearance of 4" between the
top of the appliance and the soffit.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Advertisement
Table of Contents
