Table of Contents
Advertisement
Installation
Instructions
UNPACKING SPACEMAKER'"
I-I-I Remove tope
two corner pods
rear
and
from
bottom corners ofappliance.
r2-1 using
shipping corner posts, l og
thefour
the
appliance on its left side so the shipping bose does
not rest on the floor.
Plastic spacer
block
Shipping
Shipping Rear vent
blocks
clips
only
Mechanism
"Drain hose
shipping bolt
Foam
shipping p ad
Shipping carton
corner posts
Remove the foam shipping pod.
Remove the washer shipping bolt using the ratchet
with 3/8" socket and remove the plastic spacer
block using the slip-joint pliers.
Return the appliance to the upright position
and locate it in the general area to be installed.
Provide enough space at the rear for installing
the water inlet hose.
Untope and open the washer lid.
Remove:
a. foam tub blocking pod
b. foam shipping blocks from rear of unit
c. tope from dryer door
d. foam dryer support pods
e. inlet hoses
f. From the back of the washer, remove only
the WIRE shipping clips that secure the drain
hose to the left side of the washer bocksheet.
DO NOT REMOVETHE PLASTICCLAMPS on the
right side of the washer. These clamps form
o standpipe to prevent water siphoning.
Dryer
support pads
UNPACKING SPACEMAKER'" (CONT.)
NOTE: T he tub blocking pod, shipping bolt and plastic
spacer should be retained for use if the appliance
is transported at o later dote.
I-8--1 Form
the end of the drain hose with
0
ttU_J
shape
on
hose pointed toward the drain. For on installation
requiring o longer drain hose, use WH41X0387
(approximately 112"). This drain hose attaches
directly to the pump and should be installed by
o qualified technician.
INLET HOSE CONNECTIONS
I_1
the inlet hoses and rubber washers from
Remove
the plastic bog.
r_
install the rubber washers in each end of the inlet
hoses.
I'_"1
Corefully connect the inlet hose marked "HOT"
to the bottom outlet of the water valve. Tighten
by hand; then tighten another 2/3 turn with pliers.
Carefully connect the other inlet hose to the top
outlet of the water valve. Tighten by hand; then
tighten another 2/] turn with pliers.
POWER CORD CONNECTION
SEEELECTRICALCONNECTION INFORMATION
Advertisement
Table of Contents
