Table of Contents
Advertisement
Installation
Instructions
CONNECTING
APPLIANCE USING
3-WIRE CONNECTION
r_
Remove the terminal block cover located at the
rear of the dryer.
r3q
r-4]
Instoll o UL-recognized stroin relief in the one-inch
hole on the drger back below the terminal block
opening.
Install a UL-listed 30A, 3-conductor NEHA 10-]0R-
tgpe SRDTcord with 3 open-end spade lug
connectors with upturned ends or closed loop
connectors.
Connect the center wire of the power cord to
the silver-colored center terminal screw on
the terminal block. Tighten the screw securelg.
Center
er-cotored
screw
_
Connect the two other wires of the power cord to
the outer brass-colored terminals on the terminal
block. Tighten the screws securelg.
[_
Tighten the screws securing the power cord to
the strain relief.
r_
Reinstall the terminal block coven
_4, C AUTION:
Be sure electricitg is OFFat power
source (circuit breaker/fuse box).
r_
Plug power cord into electrical outlet.
[_
Return to Step 15 on page 3.
NOTE:TH ISAPPLIANCEISNOTAPPROVEDFOR120-VOLT
OPERATION.
3-WIRE CONNECTION
(UNGROUNDED
NEUTRAL)
This appliance is manufactured with the neutral
connected to the frame. If local codes do not )ermit
neutral grounding, proceed as follows:
Remove the terminol block occess cover.
Disconnect the green ground wire from the green
ground screw.
Connect green ground wire to center (silver-
colored) terminal of terminal block.
Connect o separate grounding wire (No. 12
or heavier-not
supplied) between the green
ground screw and o grounded metal cold water
pipe or other established ground.
Groundclamp
attach to metal
cold water pipe
Ground
#12 minimum
(not supplied)
Green
groundscrew
Green
silver-colored
groundwire
screw
[_"_
Reinstall the terminal block access cover.
_4, C AUTION: Be
s ure electricitg is OFFat power
source (circuit breaker/fuse box).
[_'E]
Plug power cord into electrical outlet.
rl-_
Return to step 15 on page 3.
NOTE:TH ISAPPLIANCEISNOTAPPROVEDFOR120-VOLT
OPERATION.
Advertisement
Table of Contents
