GE 49-90383 Installation Instructions Manual page 3

Installation Instructions
MOVING SPACEMAKER'" TO OPERATING
LOCATION
r_ Remove the 2 screws securing the access panel
to the dryer cabinet. Lift the front access panel
until the tabs can be disengaged from the dryer
cabinet and remove the panel.
r_ Route the inlet hoses, drain hose and power cord
through the rear access area for temporary
holding when moving the appliance to the
operating location.
panel
screws
To ensure the Spacemaker T"is level and solid on
all four legs, tilt the Spacemaker T"forward so the
rear legs are off the floor. Gently set the
Spacemake¢" back down to allow the rear legs
to self-adjust. Place a level on top of the washer.
Check it side to side, then front to back. Screw
the front leveling legs up or down to ensure the
Spacemake¢" is resting solidly on all four legs
(no rocking of the Spacemake¢" should occur).
NOTE:Keep the leg extension at a minimum to prevent
excessive vibration.
CONNECTING TO PLUMBING FACILITIES
-ACAUTION:
Be sure water supply lines have
been thoroughlg flushed to remove particles that
might clog the washer filter screens.
r_ Determine which water faucet is the HOT water
faucet, carefully connect the bottom inlet hose
to the HOTwater faucet, tighten by hand,
and then tighten another 2/3 turn with pliers.
Carefully connect the top inlet hose to the
COLD water faucet, tighten by hand, and then
tighten another 2/3 turn with pliers.
_A CAUTION: DO NOT CROSS-THREAD
OR OVERTIGHTENTHESE CONNECTIONS.
CONNECTING TO PLUMBING FACILITIES
(CONT.}
Turn the water on and check for leaks at both connections.
r_ Place formed end of drain hose in drain facility
and secure with cable tie (provided in literature
package).
-)
"Cable tie ab_ii_[. _
NOTE:Drain hose MUSTbe secured to drain facility
in all cases.
CONNECTING TO POWER SUPPLY
NOTE:For special electrical installations, see ELECTRICAL
INFORMATION section, pages 5 and 6.
-&CAUTION: Be
sure electricity
isOFF at
power supplg source (circuit breaker/fuse box).
r_l Plug power cord into electrical outlet.
CONNECTING TO EXHAUST
r_ Connect the exhaust duct to outside ductwork.
Use duct tape to seal all joints. See EXHAUST
INFORMATION.
FINAL APPLIANCE LEVELING
_A CAUTION:
ALLWEIGHT MUST BE
REMOVEDFROM APPLIANCELEVELINGLEGWHILE
ADJUSTING.THREADS ON LEGWILL BEDAMAGED
OTHERWISE.
r_ Again, make sure the appliance rests firmly on
all four legs. No rocking of the appliance should
occur.
3