Presser Foottypes - Kenmore 385. 17922 Owner's Manual

=
Change the PresserFoot (Continued)
To Snap On
f
Groove _ Pi_n
To Snap On the Presser Foot:
1. Place the presser foot so the hori-
zontal pin on the foot lies just
under the groove of the foot
holder.
2. Lower the presser foot holder to
lock the presser foot in place.
NOTE:
If you do not hear the
presser foot snap in place,
press down on the presser
foot holder firmly until you
hear the snap.
Presser Foot Types
Zigzag Foot
A: Zigzag foot
Use this foot for both straight and z_gzag
stitcing.
Uses:
Zigzag stitchrag tsee page 36),
Bar tacking (see page 38),
Button sewing (see page 40),
Overcasting stitch (see page 41),
Blind hemming (see page 42),
Lace work (see page 43),
Three-step zigzag (see page 44),
Box stitching (see page 45),
Fagoting (see page 46),
Two-point shetl stitching
(see page 47),
Rick-rack stretch (see page 49),
Overcast stretch (see page 50),
Smocking (see page 50),
Elastic stretch (see page 51),
Stretch patching (see page 52),
Herring bone stretch (see page 52),
Twin needle stitching {see page 55).
Straight Foot
H: Straight foot
Use this foot exclusively for straight stitching
using center needle position oniyo
Uses: Strmght stitching (see page 31),
Topstitching (see page 32),
Straight stretch (see page 49).
t2