Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all wireless
network settings are reset to their default values.
TCP/IP
Purpose:
To specify the TCP/IP settings for the wireless network. The change becomes effective after the printer is
turned off and then on again.
Values:
1
IP Mode*
Dual Stack
IPv4 Mode
IPv6 Mode*
IPv4
Get IP Address
IP Address
Subnet Mask
Gateway Address
2
Reset IPsec*
1
*
Only displayed when an optional multi-protocol card is installed on the printer.
2
*
Only displayed when IPsec is enabled.
Uses both IPv4 and IPv6 to set the IP address.
Uses IPv4 to set the IP address.
Uses IPv6 to set the IP address.
3
Automatically sets the IP address.
AutoIP*
Uses BOOTP to set the IP address.
BOOTP
Uses RARP to set the IP address.
RARP
Uses DHCP to set the IP address.
DHCP
Enables the IP address entered on the operator panel.
Panel
Sets the IP address allocated to the printer by using the
keys on the operator panel.
Sets the subnet mask.
Sets the gateway address.
Disables IPsec.