Esc I M 2D Barcode (Maxicode) - Brother RJ-4030 Software Manual

ESC i M 2D barcode (MaxiCode)
ASCII: ESC
Decimal: 27
Hexadecimal: 1B
Format: ESC
Parameters
(1) [Parameters]
If a value other than those listed is entered for a parameter, that parameter is specified with its default
value.
1. Symbol
type [1-byte decimal]
[1-byte decimal]
[1-byte decimal]
2. Structured [1-byte decimal] 0
Append [1-byte decimal] 1
setting
(2) \ (backslash)
Separator between parameters and barcode data
(3) [Barcode data]: Barcode data
The number of barcode data characters that can be entered is listed below.
Symbol Type
Standard
Full EEC
Structured carrier message
Note
The numbers of characters that can be entered (as listed above) are for when using only the
common character set (code set A in the MaxiCode specifications). The number of characters that
can be entered may decrease, depending on the characters that are used.
i M or m data
105 77 or 109 data
69 4D or 6D data
i M or m [Parameters]
0
1
2
Maximum Amount of Information Allowed
Alphanumeric Characters
- 76 -
\ [Barcode data]
(1) (2)
Standard (default value)
Full EEC
Structured carrier message
With Structured Append
Without Structured Append
93
77
84
ESC/P Command Reference
\\\
(3) (4)
(default value)
Numbers
138
113
126
5. Control Command Details