Honeywell HD-16DVR-C User Manual page 141

Please refer to the following sheet for detailed information.
Parameter Function
There are three types: Motion detection/video loss/Camera
Event Type
Masking.
Select channel name from the dropdown list, and check the
Channel
checkbox beside it to enable its motion detection function.
There are six levels. The sixth level has the highest
Sensitivity
sensitivity.
There are six levels. The sixth level has the highest
sensitivity.
Region: If you select motion detection type, you can click
this button to set motion detection zone. The interface is
Region
shown in
zones. Right-click and you can go to the full-screen display
mode. Do remember to click OK to save your motion
detection zone setup.
Motion detection function becomes activated in the specified
periods.
There are six periods in one day. Please check the
checkbox to enable corresponding period.
Period
Select date. If you do not, the current setup applies to today
only. You can select all week column to apply to the whole
week.
Click OK, and the system goes back to motion detection
interface; please click Save to exit.
Anti-dither Not Effective in the current DVR version.
There is 3-channel alarm output.
Corresponding to motion detection alarm output port
(multiple choices)
Alarm out
Enable alarm activation function. You need to select alarm
output port so that the system can activate the
corresponding alarm device when an alarm occurs.
System can delay the alarm output for a specified time after
Alarm latch
a detection event ends. The value ranges from 10s to 300s.
System auto activates motion detection channel (multiple
choices) to record once alarm occurs (working with motion
Record detection function). Please note you need to go to the
channel chapter
period and go to the chapter
set the current period as auto record.
System can delay the record for specified time after a
Record latch
detection event ended. The value ranges from 10s to 300s.
Figure 6-40. There are PAL 22X18/NTSC 22X15
Schedule on page 35 to set motion detection record
Manual Record
Honeywell
on page 27 to
125