Installation - Honeywell TB7200 Series Application Manual

Typical PIR Detection Pattern
60°
15°
15°
ZONE NOT RELIABLE
Fig. 3. Typical Horizontal Angle

INSTALLATION

WARNING
Electronic controls are static sensitive devices. Discharge yourself properly before manipulation and installing
the thermostat and its accessories.
Short circuit or wrong wiring may permanently damage the thermostat or the equipment. All TB7200 and 7300 Series
thermostats are to be used only as operating controls. Whenever a control failure could lead to personal injury and/or loss
of property, it becomes the responsibility of the user to add safety devices and/or alarm system to protect against such
catastrophic failures.
Tip Type
General Installation
Initial Power Up &
Commissioning
PIR APPLICATION GUIDE FOR TB7200 AND TB7300 SERIES THERMOSTATS
0°
60°
15°
15°
ZONE NOT RELIABLE
M21308
Table 2. Installation Tips
Area Of Interest
PIR Connector Polarized connector is located at bottom left hand corner of TB7200
or TB7300 Series thermostat
Security Screw A security screw has been provided in the thermostat box. This
screw should be carefully installed in the intended mounting position
located bottom center of thermostat cover.
PIR Warm up PIR Sensor may take up-to 60 seconds after initial warm up period to
period detect movement consistent with typical detection pattern.
Visual indication Visual indication of PIR activity for commissioning is provided via a
(Status of PIR) blinking LEDs located on the thermostat cover under the PIR lens.
LEDs will be active while occupant is in field of detection pattern for a
period of 30 minutes after initial power up.
CENTER
Fig. 4. Typical Vertical Angle
Explanation
33
20 FEET
45°
M21309
63-4526—01