GE Appliances JVE40 Owner's Manual And Installation Instructions page 12

Installation Instructions
[_ CHOOSE VENTING OPTION
The hood can be set to vent outside or to recirculute air
back into the kitchen.
. To vent to the outside, refer to steps 5 and 6.
, To recirculate air into the kitchen, remove two
screws securing the duct block off plate. Discard
plate. Replace two screws.
Note: Hood is ENERGY STAR ® certified only when it vents
air to the outside.
r9] FOR RECESSED-BOTTOM CABINETS
ONLY
Wood shims
. If the cabinets have front, side or back trim, make
2 wood shims the width of the trim and attach them to
the cabinet bottom recess on both sides. See Step 7 for
marking locations.
[_] CUT HOLES
Cut holes at marked locations for duct and electrical
wiring. For the vertical duct, cut out 3/4" extra toward
the front of the cabinet so you can move the duct
freely when installing the hood. It may also ease
installation by cutting the hole !0½" instead of !0".
[] RUN WIRES
Run the electrical wires through the wall or cabinet
according to National Electrical Code and applicable
local codes.
NOTE: DO NOT turn the power on until installation is
complete.
r_] SCREW IN PARTWAY
Drive a mounting screw (from the hardware packet)
partway into each center of the narrow neck of the
keyhole slots marked on the cabinet bottom.
FEED IN WIRES
Lift the hood into position and feed the house
wiring through the wiring knockout.
[_] SECURE HOOD
Slide the hood back against the wall. Tighten the
mounting screws. Be sure the screw heads are in
the narrow neck of the keyhole slot.
Keyhole (4)
12