Mitsubishi VS-5041 Owner's Manual page 90

_Important:
using the quick program button (QUICK PROGRAM)
When you press QUICK PROGR_-M to begin programming your
VCR:
• Active A/V Network will turn o:n your VCR and bring it to the
"Program to Record" screen. If 1;he VCR's clock ha,_ not been set,
you will see the "Set the clock" screen. (See your VCR's Owner's
Guide for information about setting the clock.)
• Active A/V Network will turn on your Projection TV (if it is off),
and switch the Projection TV to EXT-1.
You can program your VCR by pointing your remote control at the
Projection TV.
When you press QUICK PROGRAM to end programming your
VCR:
• Active A/V Network will turn offyour VCR (unless a tape is
currently playing or recording).
• Active A/V Network will return your Projection TV to the
channel it was on before, or turn :it off (if it was off originally).
using the PLAY button (AUTO PI[_kY)
When you press PLAY on the remote,:
• Active A/V Network will turn your VCR on and begin playing
the tape (if any).
• Active A/V Network will turn your Projection TV on and switch
it to EXT-1.
When you turn your Projection TV off:
• Your VCR will turn off, unless :it iis playing or recording.
using the PIP button (TWO TUNER PIP)
You must be watching a broadcast channel on Antenna-A or
Antenna-B to use the Active A/V Network PIP function correctly.
When you press the PIP button on the remote to bring up a PIP
image:
• Your VCR will automatically turn on.
• You can see the VCR's picture in the small PIP image.
92 Chapter 4: Using the Special Features