Mitsubishi VS-5041 Owner's Manual page 58

Setting the A/V Network
_Important:
_Important:
_Important:
The A/V Network is a system that Mitsubishi developed to make it
easier to operate many products together. When the A/V Network
is connected between two Mitsubishi product,, you can point the
remote control at one product and i_ will "pass" _he remote control
command to the other. To set up the A/V Network:
F{rst Time Set-Up
Set the clock
Memorize channels
Addldetete channels
II_ Set NV Network
Align colors
Use ADJUST to select
"Then press ENTER.
Press MENU to return to
TV Main Menu.
Set A/V Network
_' Off
Basic
Active
Use ADJUST to select,
Then press ENTER.
Press MENU to return to
First Time Set-Up Menu.
O Press tlhe MENU button on the
remote control. The Main Menu
will appear on the screen.
O Select "'Firs_ Time Set-Up"
using the ADJUST bu_ttons;
then, press ENTER.
O Use ADJUST to select "Set A/V
Network"; then, pres,,_ ENTER.
0 Use the ADJUST buttons to
select "Active," "Basic," or "Off."
Check. the rear terminals of
your VCR, then use the ('hart
below to determine how you
should set your Projection TV.
O Press the ENTER or MF,NU
button
1:oreturn
to the "First
Time Set-Up" menu.
If your VCR has a rear ...and you have seL your ...then set your Projection
terminal that reads: VCR to: TV to:
A/V Network - Basic
Active A/V Network Off Basic
Active A/V Network Active Active
Does not have an A/V - Off
Network rear terminal
If you are not sure how to set your VCR's A/V Network setting,
refer to your VCR's owner's guide.
The A/V Network can still be used to pass remote control signals
even when the Projection TV's "A/V Network" setting i,_"Off."
If you do not use the A/V Network system, set "A/V NeLwork" to
"Off." If you don't, channel selecLion may ,_ot work correctly.
If you are using a Mitsubishi VCR with A!V Network or Active A!V
Network, you should have connected it to the External 1
(EXT-1) input of your Projection TV.
Getting Started 59