Mitsubishi TS-4545 Owner's Manual page 100

Troubleshooting (cont.)
Problems
Possible Solutions
For More Information
The remote control doesn't
work.
• Check that the batteries are
installed correctly.
See "Getting resdy to use
the remote contror' in
Chapter 1 for an explanation
of ihow to install batteries in
the remote control.
Check that the select switch
is set to "TV."
See "Remote control buttons
and functions" in Chapter 1,
which explains where the
select switch is located.
Be sure that you are
pointing the tip of the
remote control toward the
TV from a distance of no
more than 20 feet.
See "Getting: ready to use
the remote contror' in
Chapter 1, which contains
pointers for using the remote
control.
The TV takes several
seconds to respond to button
commands.
• Use the ENTER button to
avoid delays.
See "Changing channels" in
Chapter 3, which explains
the function of the ENTER
button.
You can't access a channel. Be sure that the channel you
want to view is programmed
into memory.
Check that the TV is tuned
to the correct input source
(antenna) for that channel.
See "Memorizing channels"
in Chapter 3, which explains
how to program channels
into the TV's memory.
See "Selecting tlhe input
source" in Chapter 3, which
explains how to change the
input source.
You can't see a different
channel in the reduced PIP
image.
• Use the SOURCE button to
change the source of the PIP
image.
Make sure you have a
second source, such as a
VCR, turned on and con-
nected to your TV.
• See "Using the Picture-in-
Picture (PIP) Modes" in
Chapter 4.
102 Chapter 5: Troubleshooting