Mitsubishi S6085 Operating Manual page 23

Using the remote control to operate VCRs, cable
boxes, and other components (cont.)
setting up the remote control to operate your Mitsubishi
audio component (laserdisc player or A/V receiver)
O Turn off your audio component.
O Press one of the select buttons across the top of 1;he remote to
choose the layer you want to set up. For a laserdisc player:,
choose AUX or VCR-B. For an A/V receiver, Choose TV or AUX.
While holding in the POWER button on the remote control,
enter one of these code numbers:
• For a Mitsubishi A/V receiver: 30 or 31
• For a Mitsubishi laserdisc player: 32 or 33
Be sure to enter both digits of the code number. If more than
one number is listed, try the first one.
Release the POWER button.
O
Press the POWER button again. Your audio component should
turn on. If it does, your remote control is now set to operate
your cable box. If it does not turn on, repeat the instructions
above, trying the other code number listed for your component.
using your remote control to operate your Mitsubishi
laserdisc player
After you have set up your remote control for your laserdisc player,
you can use the remote to operate the player.
Use the select buttons across the top of the remote control to
choose the layer that you "set up" to operate your laserdisc
player: AUX or VCR-B.
Point the remote control at the laserdisc player and press the
desired buttons.
You can use the POWER, CHANNEL, numbers (0-9), DISPLAY,
MENU, CANCEL, STOP, PAUSE, REW, PLAY, ]NDEX, and FF
buttons to operate your laserdisc player.
18 Chapter 2: Operating Your Projection TV