GE JV936 Owner's Manual And Installation Instructions page 17

Installation instructions
[_ INSTALL MOTOR
• Align and engage tile
slots in tile blower
assembly to tile 3 books
at tile rear of tile
exhaust
opening.
M0ior H ooks
* Rotate motc)r upwards _o o o r_o o
until it aligns with tile ,__,
attachment screw
location.
* Secure tile lIlo[oI" to
attachment bracket
at tile front of tile
opening with washer
_tnd
" Plug tile motor connector into /_y--_'""'_l\ "_:=='-"
tile,nati,l_ b oost co,l,lecto, See/?i,A \
• ' . ; 2.41
tile llhlstlatlon f}J, the ]lood £__
connector location. Touch tile _ )-_
hood to locate and make tile /
connection. __ _.-(_ / _"_ ) IMPORTANT: Hold tile __,_at _£r>-¢
connector so tile two square"'_ _-__j_
corner terminals are at tile top___myou %--.__
position tile connector to plug it in.
_-_ CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING: ..bo. e ,lot
2-wire with a ground wire, a ground must be provided
by tile installer When house wiring is aluminum, be
sure to use U.L. approved anti-oxidant compound
and aluminum-to-copper connectors.
A Rem0ve C usertP0wer
Junction Box ConduitThru (
Cover Strain Relief
andTighten
[__ White
Ground - --.__
Check That White, Blackand
GreenHoodWires AreThreadec
ThruSmall H01e in Bracket
D UseULListedWire Nuts
* Use wire nuts to connect incoming ground to green,
white to white and black to black.
* Push wires intoj unction box and replace covei-
Be sure wires are not pinched.
17
_-_ INSTALL DUCT COVERS
To install the 12 "duct cover alone:
* Place tlle 12" section of tile decorative duct cover on
top of tile hood.
* Secure tlle cover to tlle top of tlle hood witil 4 screws
provided.
To install the 2-piece duct cover:
* Place tile 2-piece duct cover on top of tile hood.
* Secure tile bottom cover to tile top of tile hood with
4 screws provided. See illustration, page 16.
* Extend tile inside section upwards to meet tlle
ceiling and ceiling bracket.
* Secure tlle duct cover to tlle bracket witil tlle 2 small
Phillips screws provided.
If0-] INSTALL FILTER SUPPORT
* Tip filter support into tile rear of tlle hood.
* Insert support tabs into tile slots at tile rear of
tile hood.
/
/
InsertTabsInt0Slots
• Secure tile support to tile hood witil screws as shown.