GE JV936 Owner's Manual And Installation Instructions page 12

Installation instructions
PARTS PROVIDED
Locate the hardware accessory box packed with the
hood and check contents.
2 Aluminum Screws, wall
Grease Filters fasteners, washers
Duct
Transition
with Damper
Filter
Support
DUCT COVER REQUIREMENTS
We recommend that the vent hood and decorative
duct cover (if used) be on site before final flaming and
wall finishing. This will help to accurately locate studs,
duct_,vork and electrical service. Read these instrucuons
to determine if the duct cover accessory can be used ff_r
your installation situation.
Duct Cover Accessory:
* Use the decorative duct
cover to conceal ductwork
running flom the top of
the hood to the ceiling.
* The duct cover access(n T
consists of 2 pieces. The
outside piece is 12" high,
the inside piece is 22".
Nested together they are
24" rain., expanding to
a total maximum height
of 34".
* The outside piece can
be used alone to fill a
12" height.
* For heights over 12", the
ceiling bracket must be
installed to secure the
cover at the top.
T
To avoid unsightly gaps, plan the hood installation height
for duct cover use.
* The cover will fit a 12" rain. height flon:t the top of the
hood to the ceiling, or 24" rain. and expanding up to
34" flom the top of the hood to the ceiling.
THE DUCT COVER CANNOT BE USED WHEN THE
DISTANCE ABOVE THE TOP OF THE HOOD IS
BETWEEN 12 "AND 24".
Review the fbllowing examples to ensure a trouble flee
installation using the duct cover accessory.
8ft. Ceiling
8 R. Ceilings: The hood must
be installed at30"above the + I II
• 12"
cookmg surface (or 66 above
the floor). The duct cover will
II V
not fit if the hood is installedat II /
a lower or higher height. Use II /
the outside 12"section, discard II LZl_l
f
the inside section. _ /
30"
--II t r--
9 ft. Ceiling
9 R. Ceilings: Install the hood 24" min. and up to a maximum of 30"
above the cooking surface. The duct cover will expandto reach
ceiling height,
10ft, Ceiling
3_0"
{g*
32" 36" Max.
--II IF --lr 11--
10 ft. Ceilings: Install the hood 32" min. to 36" max. above the cooking
surface. The duct cover will expand to a maximum of 34"above the
top ofthe hood to meet the ceiling.
12