GE JV936 Owner's Manual And Installation Instructions page 16

Installation instructions
iNSTALL CEiLiNG BRACKET
The ceiling bracket must be installed when the duct
cover is used to span 24" or more height above the
hood. The bracket will hold the decorative duct cover
in place at the top.
Note: The ceiling bracket is not required when using
only the 12" section of the duct cover
* Install the 2 small screws into the sides of the duct
bracket. Remove the screws. Pre-mpping the holes
will instlre ease of final installation.
* Match center notch on the bracket to the centerline
on the wall and flush against the ceiling.
* Mark the 2 screw hole locations.
* Drill 1/8" pilot holes in marked bracket location.
* If pilot holes do not enter studs, enlarge the holes to
3/8" and install wall fastener anchors.
* Secure the bracket to the rear wall with wood screws
and washers. Use wall anchors if needed.
Note: Bracket has 2 sets of holes. Use larger holes for wall
fasteners or wood screws with washers. Use smaller holes for
wood screws with washers.
Install
CeilingBracket
WhenDuct
Coveris
Usedto Span
24"or More
See Step 9
to Install
Duct Cover
CONNECT DUCTWORK
* Push duct over the end of the transition undl it
reaches the stop robs°
* Install ductwork, maldng connections in direction of
airflow as illustrated.
* Secure joints in ductwork with sheetmetal screws.
* Wrap all duct joints with duct tape for an airtight
seal.
* Use duct rope to seal the flange connection.
HouseDuctworl<
DuctTape
OverSeam
andScrew
DuctTape
Onlyfor Proper
Operation
of Damper _/
J
DuctTapeJ
OverFlange
Air Flow
Screw
Ductworl<
Duct
Stops
siti0n
ACAUTION"
[] Do not use sheet metal
screws at the transition to ducta, vork connecfiono
Doing so will prevent proper damper operations.
Seal connection with rope only.
16