Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes From Motor Unit Memory; 3-Button Remotes - Craftsman 139.53918D Owner's Manual

PROGRAMMING
NOTICE:/f this Security,F_ garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver of
the garage door opener, which provides security against code-theft devices, will be circumvented. Theowner of the copyright in the
garage door opener does not authorize the purchaser or suppfier of the non-rolling code transmitter to circumvent that technical
measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will
open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security+ ® 315 MHz remote controls.
USINGTHE "LEARN" BUTTON
To Add or Reprogram a Hand-he/d Remote Contro/
USINGTHE DOORCONTROL
1. Pressand releasethe "learn" button on
the motor unit. The learn LEDwill glow
steadilyfor 30 seconds.
2. Within 30 seconds,press and hold the
button on the hand-heldremote*that you
wish to operateyour garagedoor.
3. Release the button whenthe motor unit
lights blink. It has learnedthe code. If
light bulbs are not installed,two clicks
will be heard.
\l/
1. Pressthe Learn button on the door control.
2. Pressthe Learn button again to confirm
Learn Mode.
3. Pressthe button on the hand-heldremote*that
you wish to operateyour garagedoor.
4. Whenthe motor unit lights blink, it has learned
the code. If light bulbs are not installed,two
clicks will be heard.
\1 /
To Erase A// Codes From Motor Unit Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the purple "learn" button on
motor unit until the learn LEDgoes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
*3-Button Remotes (315 MHz)
If provided with your garage
door opener, the large button
is factory programmed to
operate it. Additional buttons
on any Security-I.® 3-Button
remote or compact remote can
be programmed to operate other Security-I - ® garage door
openers.
37